2019年6月3日星期一

(Solved)Saab 2008 9-3 Aero TTid with a fault

Car model and year: Saab 2008 9-3 Aero TTid

Errors:
It won't rev from cold at all for about a minute, then sound to pick up a bit and does fine. It has no power and will pull gently but then when pushed come up with limited performance.
It also says dpf full, it has been apparently from before I got it on the last 2 mots, I have taken it off, cleaned it through and back on, still says it, no fault codes read on my generic obd tool that is quite good with other Saabs so a but stuck to what may be wrong.

GM Tech2 yes:
Maybe the ECU is stuck in a regen loop and hasn't been able to complete, or you could have a DPF sensor problem
Need to get the feedback from GM Tech2 to see what the pressure values are and then probably force a regen with Tech2 to set
a baseline with the ECU.

It is sure GM Tech2 work well with SAAB 9-3.
but you have to have a Saab Card installed which you can buy and do yourself. And if you have a 2003,4 or 5 you will have to have a newer card and a candi adapter and if you have a 06 or above you have to go on line and pay by the hour.
The candi adapter is packed with the GM TECH2 and the card is about 22USD.

Where to have GM Tech2?
Look here for GM Tech2
www.obd2eshop.com/wholesale/tech2-diagnostic-scanner-with-tis2000.html
tech2-02-768x1024

Opcom yes:
Might be worth trying Opcom as its cheap and plays well with the TID's not so sure re TTID though.
Opcom will work mostly OK with TTid's too.
opcom-saab-9-3-01 opcom-saab-9-3-02 opcom-saab-9-3-03 opcom-saab-9-3-04

Look here for Opcom
http://www.obd2eshop.com/wholesale/opcom-op-com-can-obd2-opel-firmware.html
opcom-saab-9-3-05


http://blog.obd2eshop.com/solution-saab-2008-9-3-aero-ttid-with-a-fault/

没有评论:

发表评论